Air Astana Flight 1388 was a repositioning flight from Lisbon to Almaty, with a refueling stopover at Minsk. On 11 November 2018, shortly after takeoff it suffered severe control issues. After 90 minutes it landed safely at Beja Airbase.[1][2][3]

This article relies largely or entirely on a single source. (May 2021)

Air Astana Flight 1388

P4-KCJ, the Air Astana Embraer ERJ-190 involved, six months before the incident
Accident
Date	11 November 2018 (2018-11-11)
Summary	Severe control issues, maintenance error
Site	Near Lisbon, Portugal
Aircraft
Aircraft type	Embraer ERJ-190LR
Operator	Air Astana
IATA flight No.	KC1388
ICAO flight No.	KZR1388
Call sign	ASTANALINE 1388
Registration	P4-KCJ
Flight origin	Alverca Air Base, Portugal
Stopover	Minsk National Airport, Minsk, Belarus
Destination	Almaty International Airport, Almaty, Kazahstan
Occupants	6
Passengers	3
Crew	3
Fatalities	0
Injuries	1
Survivors	6

Aircraft and crew

P4-KCJ, the incident aircraft, was an Embraer ERJ-190LR operated by Air Astana of Kazakhstan. Prior to the incident it had accumulated a total of 13,152 flight hours.[1][3]

The plane was flown by Captain Vyacheslav Aushev, First officer Bauyrzhan Karasholakov and First officer in jumpseat Sergey Sokolov.[4][3] Three engineers travelled as passengers.[2]

Maintenance

On 2 October 2018 the aircraft arrived at Alverca Air Base to undergo heavy maintenance at an OGMA maintenance facility. The maintenance consisted of accomplishing several service bulletins. On 9 October the overhaul of aileron cables was initiated. The first service bulletin consisted of replacing pulleys and structural supports of the cables. The second one consisted of replacing the stainless steel cables with carbon steel cables. The cables were also lubricated.[1][3]

On October 26 during operational tests, a warning message (FLT CTR NO DISPATCH) alerted the maintenance crew that the aircraft was unfit for flight due to control system problems. The warning occurred again on 31 October. The troubleshooting lasted until 11 November, the date of the incident.[1][3]

Flight

The aircraft took off at 13:31, with the crew failing to detect the ailerons' anomaly during the operational check procedures. Visibility was limited - between 2000-3000m. Shortly after take-off the pilots noticed severe control issues. The pilots tried to turn on the autopilot, but it failed to engage. At 13:37 the crew requested a climb to FL 100 and an immediate return to Alverca, reporting flight control problems. At several instances the plane suffered complete loss of control, flipping over and diving sharply, placing stress on the airframe. The crew requested a heading to the sea so they could ditch if it became inevitable, but struggled to comply with any headings given by ATC due to their difficulty controlling the aircraft.

The crew discussed the options available to them, with the first officer in the jumpseat coordinating with the technicians on board as passengers to discover the cause of the upsets and establish an action plan. Despite no warnings indicating issues with normal mode, the crew activated the direct mode for flight controls which disconnects the FCM (flight control module) from the controls. This considerably increased controllability of the pitch and yaw-axes, but control of the roll axis was still limited with the plane rolling abnormally as the spoilers would actuate and upset the aircraft with too much input. The crew flew the plane east, hoping to find better weather conditions. Two F-16s from the Portuguese Air Force took off from Monte Real Air Base to escort the aircraft to Beja Airbase. After two go-arounds due to unstable approaches, the active first officer changed places with the other one in the jumpseat. On the final approach, the plane was bound for runway 19R but eventually landed on 19L due to the aircraft drifting on the approach.

All on board were shaken, but the only injury was one passenger who suffered a leg injury. The hull was deformed and the leading edges of the wing were wrinkled. Some parts of the aircraft suffered loads greater than they were designed for. The aircraft was written off[1] and subsequently scrapped.[5][3]

Investigation

The investigation revealed that the aileron cables were installed incorrectly. This caused reversal of aileron controls. Since the roll control surfaces include spoilers, which weren't affected by the mistake, the situation couldn't have been handled with just reversing inputs.[1]

The investigation blamed the manufacturer of the airplane for unsatisfactory maintenance instructions, the supervising authorities for lack of oversight over the maintenance crew, who lacked the skill to perform the heavy maintenance, and the flight crew for failing to notice the condition during pre-flight control checks.[1][3]

Filmography

This accident will be recreated on the Canadian television show Air Crash Investigation, on National Geographic Channel.[6]

See also

• China Northwest Airlines Flight 2303
• China Airlines Flight 006 - another flight that suffered loss of control and immense G-forces
• Forced landing of a German Air Force Bombardier Global 5000 with partly reversed flight controls

References

На других языках

[it] Volo Air Astana 1388